Maintenance Table by Vehicle

The thermostat was replaced and the cooling system pressure-tested. 

The driver's door window regulator was replaced. 

The engine oil and filter were changed, the front brake pads and rotors replaced, the oil pan gasket re-sealed, and the power steering belt replaced. A general tune up was also performed.

Replacement of points and condenser to address no-start issue. 

Both front wheel bearings and the throttle return springs were replaced; new tires were also installed. 

The gas tank ventilation system was repaired with new lines at the vent tank and canister.

The cooling system was substantially updated with a new water pump, fan clutch, and associated hardware. 

The customer provided a replacement thermostat gasket and air intake supply hoses for replacement; the chassis was also lubricated at this time. 

State inspection and replacement of backup light switch and steering wheel horn contact button

Gaskets, bearings, gear needles, reverse idler and main shaft gear replacement 

Final bill for comprehensive bodywork restoration and A/C system repairs. 

The water pump and trunk lock cylinder were replaced, and a set of aftermarket lap belts installed.

Annual servicing with various fluid flushes performed and an extensive servicing of the transmission, with the clutch, various bearings, and other components replaced.

An engine oil and filter service was performed, three V belts were replaced, and the air filters were replaced. An exhaust leak was also repaired.